Month: December 2019

DelTang Tx22 Assembly

As I have already mentioned in my post on powering my porter loco with Li-Ion accus, I’d like to experiment with the DelTang system. There’s a lot of positive feedback from other model railroaders and all my requirements seem to be met – with further room for improvements.

Unfortunately, with the upcoming Brexit the demand for DelTang components has skyrocketed at the moment (meaining autumn 2019). I was lucky to get my hands on one Tx22 transmitter and two Rx65c receivers. It will suffice for the moment, but I will need further components, especially spares.

Continue reading DelTang Tx22 Assembly

New Construction Report: Biplane “Joyrider”

About half a year after I started flying with my EasyGlider the desire for another model aircraft grew stronger.

I soon realized that I’d have to build my own models rather than buy premade ones. Especially larger models would quickly overtax my financial abilities. However, scratch building can consume a lot of money, too. So I decided to test my will: Do I really want to build a model aircraft from scratch?

Thus an old cardboard filled with balsa wood was ravaged, following the old saying: it only costs time. Taking stock, I realized that the materials wouldn’t quite suffice to build a whole plane. However, it would suffice to put my endurance under proper scrutiny.

Continue reading New Construction Report: Biplane “Joyrider”

Porter: Li-Ion Test Run

After I finished the powerpack the next opportunity was seized to perform an extensive test run.

First the pack was connected to the charger and fully charged. To be on the safe side I placed the accu pack in a fireproof bowl and thanks to the fine weather I could move the whole setup into the garden. In case that a cell had been damaged, it would have spared me the troubles of toxic fumes in my workshop.

Test run under severe supervision.

All went well, so I could plug the powerpack into the existing R/C circuit. The results were stupefying: almost three hours of solid mileage with 40% capacity remaining. Now I’m convinced that I can get up to two hours of operations out of the powerpack without overtaxing it. Next step will be the assembly of the DelTang transmitter.